[. . . ] 1000 1) – Cold - 40 °C Wool      Handwash 40 °C 30 °C      Lingerie Rinse & Spin Spin Gentle Spin Drain  : option / Yes : dosing required 1)   – – –       – – – –   – – –     – For improved garment care spin speed is restricted in these programmes Bauknecht is a registered trademark of Whirlpool USA. 5019 401 01033 CONSUMPTION DATA Programme Cotton Cotton *** Cotton Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Lingerie Temperature (°C) 95 60 40 60 40 30 40 30 40 40 30 Load (kg) 5. Programme Duration (hours : minutes)* 2:00 2:20 2:00 1:30 1:15 0:45 1:00 0:30 0:45 0:40 0:36 Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. [. . . ] ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. €¢ It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. €¢ If you select “Rinse hold” do not leave items to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” lights in the preogramme sequence indication is on. The indication lamp next to the “Start” button blinks. Terminate the “Rinse hold” option: • Press the “Start” button; the programme will terminate automatically with the final spin cycle for the present wash programme. €¢ If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start” button. “Variable spin” button • Every programme has a predefined spin speed. €¢ If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Select the new programme (with temperature), any options and another spin speed if you want. The new programme continues at the same position where the previous programme was interrupted. cANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. €¢ Press the “Reset” button for at least 3 seconds. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. The time display shows the duration of the chosen programme (in hours and minutes), and the “Start” indication lamp blinks. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lamp lights up. [. . . ] SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lamp lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. €œClean+” button • Choose this option if you use an in-wash additive for stain removal (powder, for example “Vanish”) - it will optimize the additive’s efficiency to get better wash performance and stain removal. €¢ Selectable for programmes “Cotton” and “Synthetics”; choose temperature of 30 or 40°C and use with maximum load. [. . . ]